Licensed & Insured
California state contractor license
Frigidaire Ice Maker Not Making Ice?
Ice stuck inside the tray, no water filling the mold, or the whole module is frozen solid? We specialize in Frigidaire and Electrolux refrigerators. Ice maker modules and inlet valves replaced in one visit. If we don't fix it, you don't pay.
If we don't fix it, you don't pay
Vetted Technician
Background check completed
90-Day Guarantee
On labor and parts
9 out of 10 — same day
Parts in the van. Came, fixed, done.
While You Wait — 3 Frigidaire-Specific Checks
Check the On/Off Switch
Most Frigidaire models have the ice maker switch right on the module itself inside the freezer — a wire bail or a push-button. Make sure it's in the ON position.
Look Inside the Tray
Check whether there's a solid block of ice stuck in the mold that can't eject. If yes, the ejector heater or the drive gears have likely failed.
Check the PureSource Filter
Frigidaire is very sensitive to water pressure. If your PureSource filter is more than 6 months old, pressure drops and water stops reaching the ice maker.
Dmitry
Frigidaire Appliance Tech · Orange
Frigidaire and Electrolux ice makers fail in a pattern. The two most common failures are broken drive gears inside the module and a burned-out ejector heater — the small element that warms the tray just enough to release the cubes. When it goes, ice freezes permanently in the mold.
These are inexpensive parts, and I always carry OEM Frigidaire ice maker assemblies and dual water inlet valves. Replacement takes about 30 minutes, and the module starts a new ice cycle immediately after.
Why Your Frigidaire Ice Maker Stopped — 4 Causes
Precise diagnosis in 10 minutes.
1. Ice Maker Module (Assembly) — ~50% of calls
Broken drive gears, a failed motor, or a burned ejector heater. Ice freezes in the mold and won't eject. The entire module needs replacement — it's more reliable than swapping individual gears.
2. Dual Water Inlet Valve — ~25%
Water works at the dispenser but nothing fills the ice mold. One of the solenoid coils on the dual valve at the back of the fridge has burned out.
3. Freezer Too Warm — ~15%
Frigidaire won't start an ice cycle until the freezer hits 15°F (-9°C) or below. If the freezer is running warm, the root cause — fan or defrost system — needs to be fixed first.
4. Frozen Fill Tube — ~10%
A slowly leaking inlet valve lets water drip and freeze at the fill tube entrance into the freezer. The tube gets blocked with ice. We thaw it and replace the valve.
Frigidaire Ice Maker Repair Cost
Flat labor rate. OEM Frigidaire parts. Price confirmed before we start.
| What Failed | Labor (flat) | Part | Total |
|---|---|---|---|
| Ice maker module replacement | $80 | $80–$140 | $160–$220 |
| Water inlet valve replacement | $80 | $50–$90 | $130–$170 |
| Control board replacement | $80 | $100–$180 | $180–$260 |
| Fill tube thaw + minor repair | $80 | — | $80 |
Diagnostic fee is $89 — waived when you book the repair.
Other refrigerator problems
Similar symptoms? Take a look — we fix it all.
Freezer works, but the fresh-food section is warm
Puddle under the refrigerator
Not making ice or not dispensing water
Humming, clicking, or vibrating
Clicking but won't start, or running with no cooling