Sound = diagnosis
Grinding = rollers. Squealing = idler pulley. Scraping = drum glides. Thumping = belt. Each sound is a different part.
LG dryer suddenly loud? The sound tells us exactly what's wrong.
40% of LG dryer noise is worn drum rollers. Grinding, squealing, thumping — each sound points to a different component. Shoot a quick video before calling — we'll know what to bring. If we don't fix it, you don't pay.
1–2 hours
Most noisy LG components are swapped in one visit. Standard parts — stocked in the van.
Don't ignore the noise
A worn LG roller can tilt the drum and snap the belt. Fix it early — a $40 roller repair beats a $200 belt-plus-motor job.
If we don't fix it, you don't pay
Licensed & Insured
California state appliance repair license
Free Vent Inspection
Clogged vent is a fire hazard. We check and clean it with every repair
90-Day Warranty
On parts and labor
9 of 10 Fixed Same Day
Belts, rollers, heating elements — all in the van
Dmitry
LG Dryer Tech · Orange
1,500+ dryers repaired. Noise is the most diagnostic symptom — by the time I'm at the door, I usually already know the component from the description of the sound.
Pro tip: record a short video of the noise on your phone before calling. The sound tells me which part to bring — that saves you from a second visit if I need to order something specific.
When it's urgent: if the noise comes with a burning smell, unplug the dryer immediately. That's not rollers — it's a motor bearing or a clogged duct overheating. Fire risk. Don't run it until I've been out.
How the repair works
From your call to a working dryer — here's exactly what happens
1. Call Us
Describe what's happening. Dmitry asks 2–3 questions and gives you a ballpark price on the spot.
2. Diagnostics + Vent Check
Dmitry tests the element, belt, rollers, motor — and always checks the exhaust duct. A clogged vent is a fire hazard.
3. Approve the Quote
Happy with the price — we fix it. Not happy — you only pay $89 for the diagnostic.
4. Repair + Free Vent Clean
We replace the part, clean the vent at no charge, run a full heat cycle, and show you how to prevent the issue from coming back.
5 LG dryer noises — and what each one means
Sound type → specific part. Tell me on the phone and I'll know what to bring.
1. Grinding / low rumble (40%) — drum rollers
Low hum that worsens over time. Rollers wear flat, drum sags on the shaft. Always replaced in pairs. Labor: $80. Part: $40.
2. High-pitched squeal (15%) — idler pulley
Thin metallic squeal, especially on startup. Pulley bearing is failing. Often snaps the belt if ignored. Labor: $80. Part: $25.
3. Scraping / scratching (20%) — drum glides
Plastic front or rear drum glides are worn through — drum contacts the cabinet wall. Labor: $80. Part: $30–$50.
4. Thumping / slapping (10%) — belt
Belt has stretched or partially split and is slapping the cabinet on every rotation. Often the warning before a full break. Labor: $80. Part: $20.
5. Rattling / clinking (10%) — foreign object
A coin, button, or key fell into the blower housing or drum. We remove it — free after diagnostics. Labor: $80. Part: $0.
Why we fix your dryer right the first time
The average tech: "not heating — swap the element" ($150). Didn't help. "Then the thermal fuse" ($80). Still nothing. You pay three times. Our analyzer reads amperage on the element, air temp, and vent airflow in 5 minutes. One part, one visit — no guessing.
1500
+
dryers repaired
5
min
diagnostics
95
%
fixed first visit
Quick self-check — 2 minutes
Some noise issues solve without a tech
Check pockets
Coins, keys, and screws are the #1 cause of rattling in an LG dryer. Empty pockets before every load.
Is the LG level?
Put a level on the top. An unlevel dryer vibrates and thumps — adjust the legs before calling.
Overloaded?
One heavy wet blanket in an empty drum will thump on every rotation. Add 2–3 towels to balance the load.
Lint filter clean?
A packed lint filter causes overheating — expanding metal ticks and pops. Clean it before every cycle.
Quick Diagnosis: What's happening?
Check the symptoms you're seeing to find the likely cause and repair cost
Likely a simple fix
Probable cause: belt, rollers, or thermal fuse. Repair: $100–$180, 30–45 minutes.
Professional diagnostics needed
Probable cause: heating element + clogged vent, or moisture sensor. Repair: $120–$220, 30–60 minutes.
Serious issue — call now
Multiple symptoms + burning smell — possible clogged vent (fire risk) or control board failure. Call immediately.
What does LG noise repair cost?
Labor rate is flat. Parts are at cost plus markup. We quote everything BEFORE we start.
| Issue | Labor (flat) | Part | Total |
|---|---|---|---|
| Not heating (element / gas igniter) | $80 | $40–$140 | $120–$220 |
| Drum won't spin (belt) | $80 | $20–$100 | $100–$180 |
| Won't start (thermal fuse) | $80 | $15–$70 | $80–$150 |
| Noisy / squeaking (drum rollers) | $80 | $40–$120 | $120–$200 |
| Takes too long (clogged vent / sensor) | $80 | $0–$60 | $80–$200 |
| Error code (control board) | $120–$180 | $60–$200 | $180–$350 |
Diagnostic fee: $89 — waived when you book the repair.
If we don't fix it, you don't pay. Vent inspection included free with every repair.
LG noise repairs: $120–$200 (labor + part).
40% of cases — rollers ($40 part, always replaced in pairs). Other components: $20–$50. All standard stock.
Recent LG noise repairs in Orange
Samsung DVE45, Orange — "Clothes wet after full cycle"
Lisa ran 3 cycles — clothes still damp. Ready to buy a new dryer.
Heating element burned out. Thermal fuse intact.
40 min, $200 (labor $80 + part $120)
Savings vs new: $900
Lisa ran 3 cycles — clothes still damp. Ready to buy a new dryer.
Heating element burned out. Thermal fuse intact.
40 min, $200 (labor $80 + part $120)
Savings vs new: $900
LG DLG, Anaheim — "Gas dryer, worried about safety"
Gas dryer running cold. Owner concerned about gas leak.
Cracked igniter — no spark. Gas supply and connections safe.
35 min, $170 (labor $80 + part $90)
Gas dryer running cold. Owner concerned about gas leak.
Cracked igniter — no spark. Gas supply and connections safe.
35 min, $170 (labor $80 + part $90)
Whirlpool Cabrio, Tustin — "Stopped spinning mid-cycle"
Dryer stopped spinning with wet clothes inside.
Drive belt snapped. Drum rollers partially worn.
35 min, $140 (labor $80 + part $60)
Dryer stopped spinning with wet clothes inside.
Drive belt snapped. Drum rollers partially worn.
35 min, $140 (labor $80 + part $60)
Questions before you call
Depends on the sound. A roller grind — you have a week or two, but a worn roller slowly scores the drum shaft. Once the shaft is scored, you're looking at $200+ instead of $40. Better to fix it now.
Belt slapping — don't wait. The belt can snap mid-cycle, which jams the drum and can burn out the motor. That turns a $100 repair into $300+.
Something changed. Most likely a leg shifted (check all four legs are touching the floor evenly), or a counterweight mount came loose. Not expensive ($50–$80), but finding it yourself is awkward — easier to have a tech locate and tighten it in 20 minutes.
Classic idler pulley bearing failure. Cold bearing squeals, warms up and the sound fades. It won't fix itself — the pulley will snap, drum stops. Part is $25, labor $80. Don't wait on this one.
Yes — unplug the dryer immediately. Burning smell with noise is either motor bearings or a seriously clogged exhaust duct. Both are fire risks. Don't run it until we've been out to inspect.
Most dryer repairs run $120–$220 total (labor + part). The most common issues — belt, rollers, heating element — are $20–$140 for the part and $80 for labor. We quote the exact price before we start, after diagnostics.
Depends on the machine. Here's how Dmitry looks at it:
Dryers are the most repair-friendly appliance out there. Parts are simple and cheap: belt $20, rollers $40, element $80, thermal fuse $15. They last for years — no sensitive electronics dying after three.
Real example: A Whirlpool 22 years old — replaced rollers twice at $40 each. Still runs. A Samsung 5 years old — control board failed, $400 repair. The old one was more reliable.
Exception: motor + board + element all at once on a 15+ year-old machine — we'll do the math together. If the repair exceeds $400 and the dryer is over 12 years old, sometimes a new one makes more sense.
Average repair: $150. New dryer: $700–$1,500 plus wait time. Full breakdown: repair vs. replace →
If we don't fix it, you don't pay. You only pay $89 for the diagnostic (service call + analyzer). More about our guarantee →
We're based in Orange. Usually 2–3 hours from your call. 9 out of 10 dryer repairs are done same-day: belts, rollers, heating elements — we carry them in the van.
Yes, if the vent is clogged. Wet lint builds up → overheating → ignition. According to NFPA, roughly 2,900 dryer fires happen in the US every year.
We clean the vent duct free with every repair. If it's been a while — call us, we'll check it. Usually $80–$150 if it's just a cleaning with no repair.
70% of the time — yes, it's a clogged vent or flex hose. The element heats, but humid air can't escape. We check airflow with the analyzer.
The other 30%: moisture sensor or heating element running below capacity. The analyzer shows which one in under 5 minutes.
A handyman does a bit of everything. Appliance repair is its own licensed specialty in California.
We have a diagnostic analyzer for pinpoint accuracy, a van stocked with parts, and direct supplier relationships with Samsung, LG, Whirlpool, and Maytag. A handyman will Google it — we see these failures every day.
$89 — waived when you go ahead with the repair. If we don't fix it, you don't pay. You only pay the diagnostic fee if you decide not to proceed.
What customers say
★ ★ ★ ★ ★
Loud squeaking every rotation on our Samsung DV. Tech said Samsung drum rollers wear unevenly and you have to replace all four at once or the noise comes back in 6 months — replaced all of them. Silent now.
★ ★ ★ ★ ★
GE dryer sounding like a freight train. Worn drum glides — GE uses plastic glides that wear down fast. Tech replaced them and the felt seal in 40 min. Runs like new.
★ ★ ★ ★ ★
Miele T1 grinding noise. Tech diagnosed drum glides on the first visit — ordered the Miele OEM part and returned in 2 days. $280 for a $3,500 dryer. No hesitation.
Useful pages
When fixing your dryer makes sense — and when it doesn't
tS, hE, dE — what they mean and what the repair costs
If we don't fix it, you don't pay. 90 days on parts and labor
Recent repairs nearby
35 min $140Dryer stopped spinning with wet clothes inside.
40 min $200Lisa ran 3 cycles — clothes still damp. Ready to buy a new dryer.
30 min $80Amy's dryer taking 3 hours per load. Electric bill doubled.
35 min $170Gas dryer running cold. Owner concerned about gas leak.
We repair all major dryer brands
Other dryer problems
Similar symptoms? Check if there's more than one thing going on.
LG turned your laundry room into a construction zone?
One call — LG quiet again
✓ LG rollers, belts, and idler pulleys in the van
✓ Sound diagnosis in 10 minutes
✓ $80 flat-rate labor
✓ If we don't fix it, you don't pay
7725 Gateway, Irvine, CA 92618
Пн-Пт 8:00-19:00
Ph: (949) 739-8878