Almost always the belt
Snapped belt stops the drum instantly. Motor keeps humming because it's still getting power.
Dryer hums but the drum won't turn?
80% of the time it's a snapped belt — $20 part. Less often: rollers, motor, or idler pulley. Analyzer + visual check in 5 minutes tells us exactly what failed. If we don't fix it, you don't pay.
30–45 minutes
We open the cabinet, identify the failed part, replace it, and verify the full spin cycle.
Parts on board
Belts, rollers, and pulleys for Whirlpool, Samsung, LG, Maytag, Kenmore — in the van.
If we don't fix it, you don't pay
Licensed & Insured
California state appliance repair license
Free Vent Inspection
Clogged vent is a fire hazard. We check and clean it with every repair
90-Day Warranty
On parts and labor
9 of 10 Fixed Same Day
Belts, rollers, heating elements — all in the van
Dmitry
Dryer Repair Tech · Orange
1,500+ dryers repaired. "Drum won't spin" is the most common call — and usually the easiest fix.
Key signal: if the motor hums but the drum doesn't move — that's the belt or rollers. If there's no sound at all — look at the thermal fuse or door switch first (see "won't start").
My take: on a dryer 8+ years old, if the belt snapped I recommend replacing the rollers at the same time ($40 extra). They're in the same zone — a second visit for them adds $80 in labor. Not worth it. I'll tell you honestly on-site whether it makes sense.
How the repair works
From your call to a working dryer — here's exactly what happens
1. Call Us
Describe what's happening. Dmitry asks 2–3 questions and gives you a ballpark price on the spot.
2. Diagnostics + Vent Check
Dmitry tests the element, belt, rollers, motor — and always checks the exhaust duct. A clogged vent is a fire hazard.
3. Approve the Quote
Happy with the price — we fix it. Not happy — you only pay $89 for the diagnostic.
4. Repair + Free Vent Clean
We replace the part, clean the vent at no charge, run a full heat cycle, and show you how to prevent the issue from coming back.
5 reasons the drum stopped spinning
One look — 5 minutes — and we know what to fix
1. Broken belt (80%)
Most frequent cause. Motor hums, drum is frozen, you may find a rubber piece on the floor. Fixed in 30 minutes. Labor: $80. Part: $20.
2. Worn drum support rollers (10%)
Rollers are gone — drum sags and can no longer rotate. Grinding before it stops. Replaced in pairs. Labor: $80. Part: $40.
3. Failed idler pulley (5%)
The pulley that maintains belt tension has seized. Often fails alongside the belt. Labor: $80. Part: $25.
4. Burned drive motor (3%)
Rare. Motor doesn't spin — sometimes hums and stalls, sometimes completely dead. Analyzer shows amperage. Labor: $120–$180. Part: $120–$250.
5. Door switch (2%)
Total silence at startup means the switch isn't signaling 'door closed.' Labor: $80. Part: $15–$40.
Why we fix your dryer right the first time
The average tech: "not heating — swap the element" ($150). Didn't help. "Then the thermal fuse" ($80). Still nothing. You pay three times. Our analyzer reads amperage on the element, air temp, and vent airflow in 5 minutes. One part, one visit — no guessing.
1500
+
dryers repaired
5
min
diagnostics
95
%
fixed first visit
Check this yourself in 2 minutes
Sometimes you don't need a tech
Spin the drum by hand
Open the door — does it spin freely? Belt is broken. Does it grind and catch? Rollers.
Do you hear it hum?
Humming = motor is alive, issue is in the drivetrain. Silence = motor, switch, or fuse.
Door fully closed?
Many dryers have a door switch — if the latch doesn't click, the dryer won't start.
Overloaded load?
An extremely heavy wet load can stall the drum and snap the belt. Don't dry heavy blankets alone.
Quick Diagnosis: What's happening?
Check the symptoms you're seeing to find the likely cause and repair cost
Likely a simple fix
Probable cause: belt, rollers, or thermal fuse. Repair: $100–$180, 30–45 minutes.
Professional diagnostics needed
Probable cause: heating element + clogged vent, or moisture sensor. Repair: $120–$220, 30–60 minutes.
Serious issue — call now
Multiple symptoms + burning smell — possible clogged vent (fire risk) or control board failure. Call immediately.
What does it cost to fix a dryer that won't spin?
Labor rate is flat. Parts are at cost plus markup. We quote everything BEFORE we start.
| Issue | Labor (flat) | Part | Total |
|---|---|---|---|
| Not heating (element / gas igniter) | $80 | $40–$140 | $120–$220 |
| Drum won't spin (belt) | $80 | $20–$100 | $100–$180 |
| Won't start (thermal fuse) | $80 | $15–$70 | $80–$150 |
| Noisy / squeaking (drum rollers) | $80 | $40–$120 | $120–$200 |
| Takes too long (clogged vent / sensor) | $80 | $0–$60 | $80–$200 |
| Error code (control board) | $120–$180 | $60–$200 | $180–$350 |
Diagnostic fee: $89 — waived when you book the repair.
If we don't fix it, you don't pay. Vent inspection included free with every repair.
For "won't spin" specifically: $100–$180 (labor + part). 80% of cases — broken belt for $20.
One of the least expensive dryer repairs. Replacing the machine makes no sense here.
Recent 'won't spin' repairs in Orange
Whirlpool Cabrio, Tustin — "Stopped spinning mid-cycle"
Dryer stopped spinning with wet clothes inside.
Drive belt snapped. Drum rollers partially worn.
35 min, $140 (labor $80 + part $60)
Dryer stopped spinning with wet clothes inside.
Drive belt snapped. Drum rollers partially worn.
35 min, $140 (labor $80 + part $60)
Samsung DVE45, Orange — "Clothes wet after full cycle"
Lisa ran 3 cycles — clothes still damp. Ready to buy a new dryer.
Heating element burned out. Thermal fuse intact.
40 min, $200 (labor $80 + part $120)
Savings vs new: $900
Lisa ran 3 cycles — clothes still damp. Ready to buy a new dryer.
Heating element burned out. Thermal fuse intact.
40 min, $200 (labor $80 + part $120)
Savings vs new: $900
LG DLG, Anaheim — "Gas dryer, worried about safety"
Gas dryer running cold. Owner concerned about gas leak.
Cracked igniter — no spark. Gas supply and connections safe.
35 min, $170 (labor $80 + part $90)
Gas dryer running cold. Owner concerned about gas leak.
Cracked igniter — no spark. Gas supply and connections safe.
35 min, $170 (labor $80 + part $90)
Questions before you call
If the dryer is 8+ years old — yes. Rollers and belt are in the same assembly. Doing them separately on a second visit adds $80 in labor. The combo kit (belt + 2 rollers + pulley) is cheaper than two separate calls. Newer machine (3–5 years) — belt alone is fine. I'll tell you on-site.
Usually one roller worse than the other — drum wobbles and lurches. Keep running it and it will snap the belt and score the shaft. Roller pair replacement: $80 + $40.
The relay is firing but the motor isn't turning. Could be the motor itself or the door switch. The analyzer identifies which component isn't receiving the signal — 5 minutes.
Most dryer repairs run $120–$220 total (labor + part). The most common issues — belt, rollers, heating element — are $20–$140 for the part and $80 for labor. We quote the exact price before we start, after diagnostics.
Depends on the machine. Here's how Dmitry looks at it:
Dryers are the most repair-friendly appliance out there. Parts are simple and cheap: belt $20, rollers $40, element $80, thermal fuse $15. They last for years — no sensitive electronics dying after three.
Real example: A Whirlpool 22 years old — replaced rollers twice at $40 each. Still runs. A Samsung 5 years old — control board failed, $400 repair. The old one was more reliable.
Exception: motor + board + element all at once on a 15+ year-old machine — we'll do the math together. If the repair exceeds $400 and the dryer is over 12 years old, sometimes a new one makes more sense.
Average repair: $150. New dryer: $700–$1,500 plus wait time. Full breakdown: repair vs. replace →
If we don't fix it, you don't pay. You only pay $89 for the diagnostic (service call + analyzer). More about our guarantee →
We're based in Orange. Usually 2–3 hours from your call. 9 out of 10 dryer repairs are done same-day: belts, rollers, heating elements — we carry them in the van.
Yes, if the vent is clogged. Wet lint builds up → overheating → ignition. According to NFPA, roughly 2,900 dryer fires happen in the US every year.
We clean the vent duct free with every repair. If it's been a while — call us, we'll check it. Usually $80–$150 if it's just a cleaning with no repair.
70% of the time — yes, it's a clogged vent or flex hose. The element heats, but humid air can't escape. We check airflow with the analyzer.
The other 30%: moisture sensor or heating element running below capacity. The analyzer shows which one in under 5 minutes.
A handyman does a bit of everything. Appliance repair is its own licensed specialty in California.
We have a diagnostic analyzer for pinpoint accuracy, a van stocked with parts, and direct supplier relationships with Samsung, LG, Whirlpool, and Maytag. A handyman will Google it — we see these failures every day.
$89 — waived when you go ahead with the repair. If we don't fix it, you don't pay. You only pay the diagnostic fee if you decide not to proceed.
What customers say
★ ★ ★ ★ ★
Whirlpool Cabrio stopped spinning mid-cycle. Belt snapped. Tech had the part in his van — 25 min, $140 total. Also replaced the drum rollers since they were almost gone. Smart call.
★ ★ ★ ★ ★
Belt snapped on our Frigidaire Gallery. Tech had the exact belt in his van. 20 min, $130. My wife had been doing laundromat runs all week — wish I'd called sooner.
★ ★ ★ ★ ★
Samsung dryer ran full cycles but clothes stayed damp. Heating element burned out. Fixed in 40 min for $200. New dryer would have been $1,100.
Useful pages
When fixing your dryer makes sense — and when it doesn't
tS, hE, dE — what they mean and what the repair costs
If we don't fix it, you don't pay. 90 days on parts and labor
Recent repairs nearby
30 min $80Amy's dryer taking 3 hours per load. Electric bill doubled.
35 min $170Gas dryer running cold. Owner concerned about gas leak.
40 min $200Lisa ran 3 cycles — clothes still damp. Ready to buy a new dryer.
35 min $140Dryer stopped spinning with wet clothes inside.
We repair all major dryer brands
Other dryer problems
Similar symptoms? Check if there's more than one thing going on.
Laundry piling up while the drum sits still?
One call — dryer spinning again
✓ Whirlpool / Samsung / LG / Maytag belts in the van
✓ Belt replacement — 30 minutes
✓ $80 flat-rate labor
✓ If we don't fix it, you don't pay
7725 Gateway, Irvine, CA 92618
Пн-Пт 8:00-19:00
Ph: (949) 739-8878