Dryer hums but the drum won't turn?
Usually a $20 belt — fixed today.
The motor hums but the drum sits still? About 80% of the time it's a snapped belt — a quick, cheap fix; less often rollers, idler pulley or motor. An analyzer + visual check in about 5 minutes tells us exactly what failed, with a fixed price up front. If we don't fix it, you don't pay.
Same-day service
One look + 5 minutes and we know what to fix. If the motor hums it's the drivetrain; total silence points to motor, switch or fuse.
Broken belt (~80%)
The most frequent cause — the motor hums, the drum is frozen, and you may find a rubber piece on the floor. Fixed in about 30 minutes.
Worn drum support rollers (~10%)
The rollers are gone, the drum sags and can't rotate — usually grinding before it stops. Replaced in pairs.
Failed idler pulley (~5%)
The pulley that keeps belt tension has seized — often fails alongside the belt, so we check both.
Burned drive motor (~3%)
Rare — the motor won't spin, sometimes humming and stalling, sometimes dead. The analyzer shows amperage.
Door switch (~2%)
Total silence at startup means the switch isn't signalling 'door closed' — a quick, inexpensive part.
Quick Diagnosis: What's happening?
Check the symptoms you're seeing to find the likely cause and repair cost
What's the likely fix?
Check what you see on the left — we'll estimate the cause, the cost and how urgent it is.
Estimate only — the analyzer confirms the exact cause on-site.
Probable cause: belt, rollers, or thermal fuse. Repair: $100–$180, 30–45 minutes.
Probable cause: heating element + clogged vent, or moisture sensor. Repair: $120–$220, 30–60 minutes.
Multiple symptoms + burning smell — possible clogged vent (fire risk) or control board failure. Call immediately.
Dryer not spinning repairs
“Whirlpool Cabrio stopped spinning mid-cycle. Belt snapped. Tech had the part in his van — 25 min, $140 total. Also replaced the drum rollers since they were almost gone. Smart call.”
“Belt snapped on our Frigidaire Gallery. Tech had the exact belt in his van. 20 min, $130. My wife had been doing laundromat runs all week — wish I'd called sooner.”
“Samsung dryer ran full cycles but clothes stayed damp. Heating element burned out. Fixed in 40 min for $200. New dryer would have been $1,100.”
★★★★★ 5.0 average · 29 verified reviews
What you get in one visit
Analyzer diagnostic
We plug in the analyzer — in 5 minutes you see amperage on the element, air temp and vent airflow on the screen. The same data we read.
Free vent inspection
A clogged vent is a fire hazard — NFPA logs ~2,900 dryer fires a year in the US. We check and clean the duct with every repair.
Can't fix it — no charge
If we can't fix it, you pay nothing. 90-day guarantee on all work, plus a 30-day follow-up call.
Why we fix your dryer right the first time
The average tech guesses: "not heating — swap the element." Didn't help. "Then the thermal fuse." Still nothing — you pay three times. Our analyzer reads amperage, air temp and vent airflow in 5 minutes. One part, one visit.
Dmitry — dryer & vent specialist
Dryer drivetrain specialist · Orange
"Drum won't spin" is the most common dryer call — and usually the easiest fix. The key signal: if the motor hums but the drum doesn't move, it's the belt or rollers; if there's no sound at all, look at the thermal fuse or door switch first.
My take: on a dryer 8+ years old, if the belt snapped I recommend replacing the rollers at the same time (~$40 extra) — they're in the same zone, and a second visit for them later adds ~$80 in labor. Not worth it.
I carry belts, rollers and pulleys for Whirlpool, Samsung, LG, Maytag and Kenmore in the van, so most of these are a one-visit, 30–45 minute job.
No price-list games, no surprises
You approve a fixed price before any work — then it doesn't move.
Recent 'won't spin' repairs in Orange
Dryer stopped spinning with wet clothes inside.
Drive belt snapped. Drum rollers partially worn.
Lisa ran 3 cycles — clothes still damp. Ready to buy a new dryer.
Heating element burned out. Thermal fuse intact.
Gas dryer running cold. Owner concerned about gas leak.
Cracked igniter — no spark. Gas supply and connections safe.
Belt snapped — worth replacing the rollers at the same time?
If the dryer is 8+ years old, yes — rollers and belt share the same assembly, and doing them separately on a second visit adds ~$80 in labor. A combo kit (belt + 2 rollers + pulley) beats two call-outs. On a newer machine (3–5 years) the belt alone is fine. I'll tell you on-site.
Drum turns but in jerks and jolts
Usually one roller is worse than the other, so the drum wobbles and lurches. Keep running it and it'll snap the belt and score the shaft — a roller-pair replacement now is the cheaper path.
I hear a click at startup but the drum doesn't move
The relay is firing but the motor isn't turning — could be the motor itself or the door switch. The analyzer identifies which component isn't getting the signal in about 5 minutes.
What does dryer repair actually cost?
Most dryer repairs run $120–$220 total (labor + part). The most common issues — belt, rollers, heating element — are $20–$140 for the part and $80 for labor. We quote the exact price before we start, after diagnostics.
Should I just buy a new dryer?
Depends on the machine. Here's how Dmitry looks at it:
Dryers are the most repair-friendly appliance out there. Parts are simple and cheap: belt $20, rollers $40, element $80, thermal fuse $15. They last for years — no sensitive electronics dying after three.
Real example: A Whirlpool 22 years old — replaced rollers twice at $40 each. Still runs. A Samsung 5 years old — control board failed, $400 repair. The old one was more reliable.
Exception: motor + board + element all at once on a 15+ year-old machine — we'll do the math together. If the repair exceeds $400 and the dryer is over 12 years old, sometimes a new one makes more sense.
Average repair: $150. New dryer: $700–$1,500 plus wait time. Full breakdown: repair vs. replace →
What if you can't fix it?
If we don't fix it, you don't pay: if we can't fix it, you pay nothing. More about our guarantee →
How fast can you get here?
We're based in Orange. Usually 2–3 hours from your call. 9 out of 10 dryer repairs are done same-day: belts, rollers, heating elements — we carry them in the van.
Is a dryer actually a fire risk?
Yes, if the vent is clogged. Wet lint builds up → overheating → ignition. According to NFPA, roughly 2,900 dryer fires happen in the US every year.
We clean the vent duct free with every repair. If it's been a while — call us, we'll check it. Usually $80–$150 if it's just a cleaning with no repair.
Taking too long to dry — is that a breakdown?
70% of the time — yes, it's a clogged vent or flex hose. The element heats, but humid air can't escape. We check airflow with the analyzer.
The other 30%: moisture sensor or heating element running below capacity. The analyzer shows which one in under 5 minutes.
How are you different from a handyman?
A handyman does a bit of everything. Appliance repair is its own licensed specialty in California.
We have a diagnostic analyzer for pinpoint accuracy, a van stocked with parts, and direct supplier relationships with Samsung, LG, Whirlpool, and Maytag. A handyman will Google it — we see these failures every day.
Have a Dryer Question? Ask Us
Describe what your dryer is doing and we'll reply the same day.
Other dryer problems
Similar symptoms? Check if there's more than one thing going on.
We Cover All of Orange County
Same-day appliance repair across 40+ Orange County cities — from the coast to the canyons. If we don't fix it, you don't pay.
One call and your dryer is spinning again
- Diagnostic analyzer — the exact fault in about 5 minutes
- Belts, rollers & pulleys in the van — most jobs 30–45 min
- If we don't fix it, you don't pay
- 90-day guarantee + 30-day follow-up call