Press start and nothing happens?
Usually a $15 fuse — fixed today.
Most often it's the thermal fuse or the door switch — two cheap parts; rarely the control board. The analyzer isolates the exact failed component in about 5 minutes, with a fixed price up front. If the thermal fuse blew, we also clean the vent that caused it. If we don't fix it, you don't pay.
Same-day service
Completely silent means no power reaching the motor (fuse / door switch / start switch); humming with no spin is a belt or rollers. We confirm which in 5 minutes.
Blown thermal fuse (~45%)
A one-time safety device — when the dryer overheats from a clogged vent it blows permanently. We replace the fuse AND clean the vent; skip the cleaning and it blows again.
Failed door switch (~30%)
The dryer won't start if it thinks the door is open. Hold the door firmly while pressing start — if it runs, that's the switch.
Burned start switch / button (~10%)
The start button or switch itself is faulty — nothing on press, or it only works sometimes.
Failed cycling thermostat (~10%)
Stuck in the 'too hot' position so the dryer won't start the heat cycle. The analyzer reads the thermostat signal.
Control board (~5%)
Rare — the board doesn't send the start signal even with everything else working. More common on modern digital models.
Quick Diagnosis: What's happening?
Check the symptoms you're seeing to find the likely cause and repair cost
What's the likely fix?
Check what you see on the left — we'll estimate the cause, the cost and how urgent it is.
Estimate only — the analyzer confirms the exact cause on-site.
Probable cause: belt, rollers, or thermal fuse. Repair: $100–$180, 30–45 minutes.
Probable cause: heating element + clogged vent, or moisture sensor. Repair: $120–$220, 30–60 minutes.
Multiple symptoms + burning smell — possible clogged vent (fire risk) or control board failure. Call immediately.
Dryer won't start repairs
“Loud squeaking every rotation on our Samsung DV. Tech said Samsung drum rollers wear unevenly and you have to replace all four at once or the noise comes back in 6 months — replaced all of them. Silent now.”
“LG gas dryer not heating. Worried about safety. Tech found a cracked igniter, replaced it, and did a full gas leak check — all included. Fast and thorough.”
“Samsung dryer ran full cycles but clothes stayed damp. Heating element burned out. Fixed in 40 min for $200. New dryer would have been $1,100.”
★★★★★ 5.0 average · 29 verified reviews
What you get in one visit
Analyzer diagnostic
We plug in the analyzer — in 5 minutes you see amperage on the element, air temp and vent airflow on the screen. The same data we read.
Free vent inspection
A clogged vent is a fire hazard — NFPA logs ~2,900 dryer fires a year in the US. We check and clean the duct with every repair.
Can't fix it — no charge
Approve the repair and the $89 diagnostic is included. 90-day guarantee on all work, plus a 30-day follow-up call.
Why we fix your dryer right the first time
The average tech guesses: "not heating — swap the element." Didn't help. "Then the thermal fuse." Still nothing — you pay three times. Our analyzer reads amperage, air temp and vent airflow in 5 minutes. One part, one visit.
Dmitry — dryer & vent specialist
Dryer no-start specialist · Orange
A dryer that won't start is easy to diagnose — the analyzer isolates it to the exact component in minutes. Key difference: completely silent means no power to the motor (thermal fuse, door switch or start switch); humming with no drum movement is a belt or rollers. Two different problems.
Important: if the thermal fuse blew, there's a reason — almost always a clogged vent duct that overheated the dryer. I replace the fuse AND clean the vent on the same visit; without the cleaning, the new fuse blows again within weeks.
Thermal fuses, door switches and start switches for all major brands ride in the van, so most of these are a one-visit fix.
No price-list games, no surprises
You approve a fixed price before any work — then it doesn't move.
Recent 'won't start' repairs in Orange
Lisa ran 3 cycles — clothes still damp. Ready to buy a new dryer.
Heating element burned out. Thermal fuse intact.
Gas dryer running cold. Owner concerned about gas leak.
Cracked igniter — no spark. Gas supply and connections safe.
Dryer stopped spinning with wet clothes inside.
Drive belt snapped. Drum rollers partially worn.
The thermal fuse blew — do I need to find out why?
Always. A thermal fuse blows because the dryer overheated, and that happens because the exhaust vent is clogged. Replacing the fuse without cleaning the vent means it blows again in weeks — so I do both on the same visit, with the vent cleaning included.
It worked yesterday and now nothing — what happened?
A sudden no-start after normal use is almost always the thermal fuse: a dryer can run for years with a partially clogged vent, then one hot load pushes it over and the fuse blows.
I hear a click when I press start but nothing else happens
The click is the relay firing, but the motor isn't running — could be the motor start winding, a capacitor, or the door switch losing signal mid-press. The analyzer isolates it in 5 minutes.
What does dryer repair actually cost?
Most dryer repairs run $120–$220 total (labor + part). The most common issues — belt, rollers, heating element — are $20–$140 for the part and $80 for labor. We quote the exact price before we start, after diagnostics.
Should I just buy a new dryer?
Depends on the machine. Here's how Dmitry looks at it:
Dryers are the most repair-friendly appliance out there. Parts are simple and cheap: belt $20, rollers $40, element $80, thermal fuse $15. They last for years — no sensitive electronics dying after three.
Real example: A Whirlpool 22 years old — replaced rollers twice at $40 each. Still runs. A Samsung 5 years old — control board failed, $400 repair. The old one was more reliable.
Exception: motor + board + element all at once on a 15+ year-old machine — we'll do the math together. If the repair exceeds $400 and the dryer is over 12 years old, sometimes a new one makes more sense.
Average repair: $150. New dryer: $700–$1,500 plus wait time. Full breakdown: repair vs. replace →
What if you can't fix it?
If we don't fix it, you don't pay. You only pay $89 for the diagnostic (service call + analyzer). More about our guarantee →
How fast can you get here?
We're based in Orange. Usually 2–3 hours from your call. 9 out of 10 dryer repairs are done same-day: belts, rollers, heating elements — we carry them in the van.
Is a dryer actually a fire risk?
Yes, if the vent is clogged. Wet lint builds up → overheating → ignition. According to NFPA, roughly 2,900 dryer fires happen in the US every year.
We clean the vent duct free with every repair. If it's been a while — call us, we'll check it. Usually $80–$150 if it's just a cleaning with no repair.
Taking too long to dry — is that a breakdown?
70% of the time — yes, it's a clogged vent or flex hose. The element heats, but humid air can't escape. We check airflow with the analyzer.
The other 30%: moisture sensor or heating element running below capacity. The analyzer shows which one in under 5 minutes.
How are you different from a handyman?
A handyman does a bit of everything. Appliance repair is its own licensed specialty in California.
We have a diagnostic analyzer for pinpoint accuracy, a van stocked with parts, and direct supplier relationships with Samsung, LG, Whirlpool, and Maytag. A handyman will Google it — we see these failures every day.
How much is the diagnostic fee?
$89 — waived when you go ahead with the repair. If we don't fix it, you don't pay. You only pay the diagnostic fee if you decide not to proceed.
Have a Dryer Question? Ask Us
Describe what your dryer is doing and we'll reply the same day.
Other dryer problems
Similar symptoms? Check if there's more than one thing going on.
We Cover All of Orange County
Same-day appliance repair across 40+ Orange County cities — from the coast to the canyons. If we don't fix it, you don't pay.
One call and your dryer runs again
- Diagnostic analyzer: $89 (waived at repair)
- Thermal fuses & door switches in the van + free vent inspection
- If we don't fix it, you don't pay
- 90-day guarantee + 30-day follow-up call