Ice stuck inside the tray, no water filling the mold, or the whole module frozen solid? We specialize in Frigidaire and Electrolux refrigerators — ice-maker modules and inlet valves replaced in one visit. We pinpoint the fault in about 5 minutes and give you a fixed price up front. If we don't fix it, you don't pay.
Same-day service
Frigidaire and Electrolux ice makers fail in a predictable pattern — we narrow it to the exact one in about 10 minutes.
Broken drive gears, a failed motor, or a burned ejector heater — ice freezes in the mold and won't eject. We replace the whole module; it's more reliable than swapping individual gears.
Water works at the dispenser but nothing fills the ice mold — one solenoid coil on the dual valve at the back of the fridge has burned out.
Frigidaire won't start an ice cycle until the freezer hits 15°F (-9°C) or below. If the freezer runs warm, the root cause — fan or defrost system — has to be fixed first.
A slowly leaking inlet valve lets water drip and freeze at the fill-tube entrance to the freezer, blocking it with ice. We thaw it and replace the valve so it doesn't recur.
Tick the symptoms you see — get the likely cause and a repair estimate in seconds
Check what you see on the left — we'll estimate the cause, the cost and how urgent it is.
Estimate only — the analyzer confirms the exact cause on-site.
Usually a dirty condenser, thermostat or sensor. Our analyzer confirms the exact cause in about 5 minutes — no guess-and-replace — and you get a fixed price before any work starts.
Several symptoms together often point to a frozen evaporator fan or defrost fault. The analyzer pinpoints the exact failed part on the spot — fixed price up front, and if we can't fix it, you don't pay.
Multiple symptoms at once can mean compressor or refrigerant trouble. The sooner we hook up the analyzer, the more we can save — same-day slots fill fast.
“Samsung ice maker quit completely. Tech ran Force Defrost mode first to rule out the icing issue, then diagnosed a dead water inlet valve. Replaced on the spot. Ice in 2 hours.”
“My LG had been making a low hum for two weeks, then stopped cooling. Tech said that's the LG Linear compressor sending a warning before it quits — caught a small refrigerant leak just in time. Recharged same day. Way cheaper than the $2,000 fridge I was eyeing.”
“Samsung French Door showed no error but the fridge section was room temp. Tech said Samsung Twin Cooling systems freeze up the evap fan before any code appears — that's exactly what happened. Fixed in 45 min. $800 in groceries saved the night before my party.”
★★★★★ 5.0 average · 29 verified reviews
We connect the device — in 5 minutes you see circuit temperatures, pressure and compressor status on the screen. The same data we do.
The labor rate doesn't change mid-job. You see the analyzer data and know exactly what you're paying for. You decide.
Approve the repair and the $89 diagnostic is included. 90-day guarantee on all work, plus a 30-day follow-up call.
The average tech eyeballs it → wrong diagnosis → orders the wrong part → comes back → you pay twice. Our analyzer shows the exact cause in 5 minutes: pressure, temperature, current draw. One part, one visit — no guessing.
Frigidaire ice system specialist · Orange
Frigidaire and Electrolux ice makers fail in a pattern. The two most common are broken drive gears inside the module and a burned-out ejector heater — the small element that warms the tray just enough to release the cubes. When it goes, ice freezes permanently in the mold.
These are inexpensive parts, and I always carry OEM Frigidaire ice-maker assemblies and dual water inlet valves. Replacement takes about 30 minutes, and the module starts a new ice cycle right after.
Before quoting a module I check the inlet pressure and freezer temperature so we don't replace a good part while the real cause is upstream.
You approve a fixed price before any work — then it doesn't move.
Jennifer, $800 in groceries. Party next day. Samsung showed no error code but fridge section room temp.
Analyzer: evap fan blocked by ice — Samsung Twin Cooling freezes fan before any code shows.
LG making low hum for 2 weeks, then stopped cooling. Prior tech charged $89, found nothing.
Condenser coils 80% blocked with dust and pet hair — LG Linear compressor running hot.
Another company diagnosed dead compressor, quoted $600.
Refrigerant pressure normal. Faulty $80 thermostat was the real cause.
Small cubes usually mean low water pressure — most often a clogged PureSource water filter past its 6-month life. If a new filter doesn't fix it, the inlet valve itself has partially failed.
We don't recommend it: the tray has a Teflon-coated interior that scratches easily, and once scratched ice sticks permanently. If ice won't eject on its own, the ejector heater or gears have failed — replacing the module is the right fix.
The hum is the water inlet valve at the rear. If it hums but no water reaches the mold, either the wall shutoff valve is partially closed or the fill tube inside the freezer is frozen solid.
Most refrigerator repairs run $160–$300 (labor + part). We give you the exact price after the analyzer diagnostic — before any work starts. The labor rate is fixed and doesn't change mid-job.
Depends on what's wrong. Here's how Dmitri puts it:
Factories today compete on price — they cut costs on materials: plastic instead of metal, cheap sensors, displays, wiring — it all shorts out and fails. A new refrigerator at $1,800–$3,500 might break for the same reason in 2–3 years.
Parts are made for technicians — they have to meet quality standards: metal, real service life. A well-done repair adds 5–10 years to a refrigerator.
A real example: Whirlpool, 18 years old — not cooling the top compartment. A fan, $20 part. 40-minute repair — runs like new. Meanwhile the neighbor's Samsung, 4 years old — control board failed. Repair: $800. New unit: $1,500. Which one was the reliable buy?
Exception: if the compressor died on a unit over 12 years old — we calculate it together. Sometimes the honest answer is "buy new." We'll say so straight.
Average repair: $180. New unit: $1,800–$3,500 plus 2 weeks waiting for delivery. More: when to repair, when to replace →
If we don't fix it, you don't pay. You only pay $89 for the diagnostic (trip + analyzer). We're motivated to fix it — that's why we invest in the equipment. More about our guarantee →
We're based in Orange. Average time: 2–3 hours from your call to a working refrigerator. Call in the morning — it'll be running by lunch.
Not always. A lot of techs bail on the job — it's easier to say "buy new" than to dig into the problem.
Dmitri will give you an honest assessment. In 8 out of 10 cases, repair is the smarter choice. If it truly isn't worth fixing, we'll say so directly — no pressure.
A handyman does a bit of everything: hang a shelf, fix a faucet, assemble furniture. Appliance repair is a separate specialty with a state license.
The difference: we carry an analyzer for precise diagnostics, a mobile parts inventory in the van, and direct supplier channels for Samsung, LG, and Whirlpool. A handyman will Google your problem — we've seen it every day this week.
$89 — applied toward the repair if you approve it. If we don't fix it, you don't pay. You pay only the diagnostic fee if you decide not to repair.
Describe what your Frigidaire is doing and we'll reply the same day.
Similar symptoms? Take a look — we fix it all.
Same-day appliance repair across 40+ Orange County cities — from the coast to the canyons. If we don't fix it, you don't pay.
Same-day slots in Orange County, CA · If we don't fix it, you don't pay