Whirlpool showing an error code?
We decode it and fix it today.
PO, d, E1 — these codes signal a system fault, or sometimes just a power interruption. Clearing a code doesn't fix the fridge; if it returns, a part needs replacing. We diagnose the exact cause in about 5 minutes and quote a fixed price up front. If we don't fix it, you don't pay.
Same-day service
Whirlpool codes (KitchenAid and Maytag too)
Clearing a code doesn't fix the fridge — if it returns, a part needs replacing.
| Code | What is happening | Repair |
|---|---|---|
| PO | Power outage — not a breakdown. The fridge lost power at some point; check food temperatures. Press any button to clear. | None, unless it won't cool after — then it's the compressor or start relay, not the code. |
| d | Defrost / damper failure — the air damper isn't opening, so the freezer feels normal but the fridge runs warm. Adaptive Defrost masks it for days before the code shows. | Damper or control board — $180. |
| E1 · E2 | Temperature sensor (thermistor) failure — E1 fridge, E2 freezer. The fridge over-freezes food or runs too warm. | Sensor replacement — $80 + part, about 30 minutes. |
| Ice / Filter light | Usually a reminder to replace the EveryDrop filter (hold the Filter button 3 seconds to reset). If ice still won't make, the fill tube is frozen or the inlet valve failed. | Filter reset, fill-tube thaw, or inlet valve. |
Don't see your code? Book a visit or call — we'll decode it.
Not sure? Run a quick self-check
Tick the symptoms you see — get the likely cause and a repair estimate in seconds
What's the likely fix?
Check what you see on the left — we'll estimate the cause, the cost and how urgent it is.
Estimate only — the analyzer confirms the exact cause on-site.
Usually a dirty condenser, thermostat or sensor. Our analyzer confirms the exact cause in about 5 minutes — no guess-and-replace — and you get a fixed price before any work starts.
Several symptoms together often point to a frozen evaporator fan or defrost fault. The analyzer pinpoints the exact failed part on the spot — fixed price up front, and if we can't fix it, you don't pay.
Multiple symptoms at once can mean compressor or refrigerant trouble. The sooner we hook up the analyzer, the more we can save — same-day slots fill fast.
Whirlpool refrigerator repairs
“My LG had been making a low hum for two weeks, then stopped cooling. Tech said that's the LG Linear compressor sending a warning before it quits — caught a small refrigerant leak just in time. Recharged same day. Way cheaper than the $2,000 fridge I was eyeing.”
“Another company said my Whirlpool compressor was dead — $600 to fix. These guys tested pressure and found the compressor was fine; just a $80 thermostat. Honest diagnosis, $160 total.”
“Samsung French Door showed no error but the fridge section was room temp. Tech said Samsung Twin Cooling systems freeze up the evap fan before any code appears — that's exactly what happened. Fixed in 45 min. $800 in groceries saved the night before my party.”
★★★★★ 5.0 average · 29 verified reviews
What you get in one visit
Analyzer diagnostic
We connect the device — in 5 minutes you see circuit temperatures, pressure and compressor status on the screen. The same data we do.
Fixed price up front
The labor rate doesn't change mid-job. You see the analyzer data and know exactly what you're paying for. You decide.
Can't fix it — no charge
Approve the repair and the $89 diagnostic is included. 90-day guarantee on all work, plus a 30-day follow-up call.
Why we get it right the first time
The average tech eyeballs it → wrong diagnosis → orders the wrong part → comes back → you pay twice. Our analyzer shows the exact cause in 5 minutes: pressure, temperature, current draw. One part, one visit — no guessing.
Dmitry — lead refrigerator technician
Whirlpool refrigerator specialist · Orange
Most Whirlpool "error codes" aren't dramatic. PO just means the power blipped. The d code is a damper or defrost issue, and E1/E2 are inexpensive sensors — all fixable in one visit.
Whirlpool, KitchenAid and Maytag share the same control platform, so the same codes show up across all three. I've worked these boards for years and read them fast.
We don't clear a code and call it fixed. If a part actually failed, clearing the display just hides it — we replace the part so the code doesn't come back.
No price-list games, no surprises
You approve a fixed price before any work — then it doesn't move.
Recent Whirlpool repairs in Orange
Jennifer, $800 in groceries. Party next day. Samsung showed no error code but fridge section room temp.
Analyzer: evap fan blocked by ice — Samsung Twin Cooling freezes fan before any code shows.
LG making low hum for 2 weeks, then stopped cooling. Prior tech charged $89, found nothing.
Condenser coils 80% blocked with dust and pet hair — LG Linear compressor running hot.
Another company diagnosed dead compressor, quoted $600.
Refrigerant pressure normal. Faulty $80 thermostat was the real cause.
My Whirlpool shows 'PO' — is it broken?
No — PO means a power outage occurred and the fridge wants you to check your food. Press any button to clear it. If the fridge then won't cool properly, that's a separate compressor or start-relay issue, not the code.
I cleared the code but it came back
That's the sign of a real failed part — the d, E1 or E2 codes return because the damper, board or sensor is still bad. We replace the part so the code stays gone.
Does this page apply to my KitchenAid or Maytag?
Yes. Whirlpool, KitchenAid and Maytag refrigerators use the same control platform and the same code set, so PO, d and E1/E2 mean the same thing across all three.
What will this actually cost me?
Most refrigerator repairs run $160–$300 (labor + part). We give you the exact price after the analyzer diagnostic — before any work starts. The labor rate is fixed and doesn't change mid-job.
Maybe I should just buy a new one?
Depends on what's wrong. Here's how Dmitri puts it:
Factories today compete on price — they cut costs on materials: plastic instead of metal, cheap sensors, displays, wiring — it all shorts out and fails. A new refrigerator at $1,800–$3,500 might break for the same reason in 2–3 years.
Parts are made for technicians — they have to meet quality standards: metal, real service life. A well-done repair adds 5–10 years to a refrigerator.
A real example: Whirlpool, 18 years old — not cooling the top compartment. A fan, $20 part. 40-minute repair — runs like new. Meanwhile the neighbor's Samsung, 4 years old — control board failed. Repair: $800. New unit: $1,500. Which one was the reliable buy?
Exception: if the compressor died on a unit over 12 years old — we calculate it together. Sometimes the honest answer is "buy new." We'll say so straight.
Average repair: $180. New unit: $1,800–$3,500 plus 2 weeks waiting for delivery. More: when to repair, when to replace →
What if you can't fix it?
If we don't fix it, you don't pay. You only pay $89 for the diagnostic (trip + analyzer). We're motivated to fix it — that's why we invest in the equipment. More about our guarantee →
How fast can you get here?
We're based in Orange. Average time: 2–3 hours from your call to a working refrigerator. Call in the morning — it'll be running by lunch.
Another tech told me to buy a new one — is that right?
Not always. A lot of techs bail on the job — it's easier to say "buy new" than to dig into the problem.
Dmitri will give you an honest assessment. In 8 out of 10 cases, repair is the smarter choice. If it truly isn't worth fixing, we'll say so directly — no pressure.
How are you different from a handyman?
A handyman does a bit of everything: hang a shelf, fix a faucet, assemble furniture. Appliance repair is a separate specialty with a state license.
The difference: we carry an analyzer for precise diagnostics, a mobile parts inventory in the van, and direct supplier channels for Samsung, LG, and Whirlpool. A handyman will Google your problem — we've seen it every day this week.
What does the diagnostic cost?
$89 — applied toward the repair if you approve it. If we don't fix it, you don't pay. You pay only the diagnostic fee if you decide not to repair.
Have a Whirlpool Question? Ask Us
Send us your code and model and we'll reply the same day.
Other refrigerator problems
Similar symptoms? Take a look — we fix it all.
We Cover All of Orange County
Same-day appliance repair across 40+ Orange County cities — from the coast to the canyons. If we don't fix it, you don't pay.
One call and your Whirlpool is running again
- Diagnostic analyzer: $89 (waived at repair)
- Whirlpool / KitchenAid parts in the van, fixed labor rate
- If we don't fix it, you don't pay
- 90-day guarantee + 30-day follow-up call