Almost always the belt
Snapped or jumped drive belt — the most common Amana failure at year 8–10. $20 Whirlpool-platform part.
Amana hums but the drum won't turn?
80% of the time it's a snapped drive belt — a $20 part on the Whirlpool platform. Sometimes it's the drum rollers or idler pulley. Dmitri knows exactly which to check. If we don't fix it, you don't pay.
30 minutes on the bench
Pop the top panel, swap the belt, check rollers and idler pulley while we're in there.
Belts in the van
Whirlpool/Amana-platform belts are standard stock — no waiting for parts in most cases.
If we don't fix it, you don't pay
Licensed & Insured
California state appliance repair license
Free Vent Inspection
Clogged vent is a fire hazard. We check and clean it with every repair
90-Day Warranty
On parts and labor
9 of 10 Fixed Same Day
Belts, rollers, heating elements — all in the van
Dmitri
Dryer Technician · Orange
1,500+ dryers repaired. A drum that won't spin is one of the most common — and least expensive — calls I get.
The tell: motor hums, drum stays still. That's almost always a belt. If there's no sound at all, the problem is upstream — thermal fuse or door switch (see "won't start").
Pro tip: if the belt snapped on an Amana that's 8+ years old, it's worth replacing the drum rollers at the same time ($40 for the pair). They're in the same assembly, and pulling it apart again in a year costs you another $80 in labor. I'll tell you honestly whether they need it.
How the repair works
From your call to a working dryer — here's exactly what happens
1. Call Us
Describe what's happening. Dmitry asks 2–3 questions and gives you a ballpark price on the spot.
2. Diagnostics + Vent Check
Dmitry tests the element, belt, rollers, motor — and always checks the exhaust duct. A clogged vent is a fire hazard.
3. Approve the Quote
Happy with the price — we fix it. Not happy — you only pay $89 for the diagnostic.
4. Repair + Free Vent Clean
We replace the part, clean the vent at no charge, run a full heat cycle, and show you how to prevent the issue from coming back.
5 reasons the Amana drum won't spin
One 5-minute inspection and we know exactly what to replace
1. Snapped drive belt (80%)
Most common cause. Motor hums, drum sits still — sometimes you'll find a rubber loop on the floor. Fixed in 30 minutes. Labor: $80. Part: $20.
2. Worn drum rollers (10%)
Drum sags and stops turning. You may hear grinding before it fully stops. Replaced in pairs. Labor: $80. Part: $40.
3. Idler pulley (5%)
The pulley that keeps the belt tensioned seized up or broke — often fails alongside the belt. Labor: $80. Part: $25.
4. Drive motor (3%)
Rare. Motor won't rotate — may hum and stall, or go completely silent. Analyzer reads the current. Labor: $120–$180. Part: $120–$250.
5. Door switch (2%)
Complete silence at startup — the machine doesn't 'see' a closed door. Labor: $80. Part: $15–$40.
Why we fix your dryer right the first time
The average tech: "not heating — swap the element" ($150). Didn't help. "Then the thermal fuse" ($80). Still nothing. You pay three times. Our analyzer reads amperage on the element, air temp, and vent airflow in 5 minutes. One part, one visit — no guessing.
1500
+
dryers repaired
5
min
diagnostics
95
%
fixed first visit
Check it yourself in 2 minutes
Sometimes you don't need a technician
Spin the drum by hand
Open the door — does it turn freely? If yes, likely the belt. If it grinds, the rollers are worn.
Do you hear humming?
Hum = motor runs, power transfer is broken (belt/pulley). Silence = motor, switch, or fuse.
Door fully latched?
The door switch must click fully closed. On NED/NGD dial models a slightly ajar door prevents startup.
Overloaded?
A very heavy wet load can stall the drum and snap the belt. Try a lighter load before calling.
Quick Diagnosis: What's happening?
Check the symptoms you're seeing to find the likely cause and repair cost
Likely a simple fix
Probable cause: belt, rollers, or thermal fuse. Repair: $100–$180, 30–45 minutes.
Professional diagnostics needed
Probable cause: heating element + clogged vent, or moisture sensor. Repair: $120–$220, 30–60 minutes.
Serious issue — call now
Multiple symptoms + burning smell — possible clogged vent (fire risk) or control board failure. Call immediately.
What it costs to fix a drum that won't spin
Labor rate is flat. Parts are at cost plus markup. We quote everything BEFORE we start.
| Issue | Labor (flat) | Part | Total |
|---|---|---|---|
| Not heating (element / gas igniter) | $80 | $40–$140 | $120–$220 |
| Drum won't spin (belt) | $80 | $20–$100 | $100–$180 |
| Won't start (thermal fuse) | $80 | $15–$70 | $80–$150 |
| Noisy / squeaking (drum rollers) | $80 | $40–$120 | $120–$200 |
| Takes too long (clogged vent / sensor) | $80 | $0–$60 | $80–$200 |
| Error code (control board) | $120–$180 | $60–$200 | $180–$350 |
Diagnostic fee: $89 — waived when you book the repair.
If we don't fix it, you don't pay. Vent inspection included free with every repair.
Specifically for "drum won't spin": $100–$180 (labor + part). 80% of cases — a $20 belt.
One of the cheapest dryer repairs you'll ever face. Buying a new machine is never the right call here.
Recent 'drum won't spin' repairs on Amana in Orange
Samsung DVE45, Orange — "Clothes wet after full cycle"
Lisa ran 3 cycles — clothes still damp. Ready to buy a new dryer.
Heating element burned out. Thermal fuse intact.
40 min, $200 (labor $80 + part $120)
Savings vs new: $900
Lisa ran 3 cycles — clothes still damp. Ready to buy a new dryer.
Heating element burned out. Thermal fuse intact.
40 min, $200 (labor $80 + part $120)
Savings vs new: $900
LG DLG, Anaheim — "Gas dryer, worried about safety"
Gas dryer running cold. Owner concerned about gas leak.
Cracked igniter — no spark. Gas supply and connections safe.
35 min, $170 (labor $80 + part $90)
Gas dryer running cold. Owner concerned about gas leak.
Cracked igniter — no spark. Gas supply and connections safe.
35 min, $170 (labor $80 + part $90)
Whirlpool Cabrio, Tustin — "Stopped spinning mid-cycle"
Dryer stopped spinning with wet clothes inside.
Drive belt snapped. Drum rollers partially worn.
35 min, $140 (labor $80 + part $60)
Dryer stopped spinning with wet clothes inside.
Drive belt snapped. Drum rollers partially worn.
35 min, $140 (labor $80 + part $60)
Questions before you call
If the Amana is 8+ years old — yes, I recommend it. The rollers are in the same assembly as the belt, and disassembling the machine a second time a year later means another $80 in labor. A belt + roller + idler pulley kit costs less than two separate service calls. On a newer machine (3–5 years old) the belt alone is fine. I'll call it on-site based on what I see.
Usually worn drum rollers — one has worn more than the other, causing the drum to drop and lurch. Don't ignore it: continuing to run risks snapping the belt and bending the drum shaft. Roller replacement runs $80 + $40.
The click is the relay engaging, but the motor isn't spinning up. Could be a seized motor or a failed door switch. The analyzer traces the signal path in 5 minutes and tells us exactly which node isn't responding.
Most dryer repairs run $120–$220 total (labor + part). The most common issues — belt, rollers, heating element — are $20–$140 for the part and $80 for labor. We quote the exact price before we start, after diagnostics.
Depends on the machine. Here's how Dmitry looks at it:
Dryers are the most repair-friendly appliance out there. Parts are simple and cheap: belt $20, rollers $40, element $80, thermal fuse $15. They last for years — no sensitive electronics dying after three.
Real example: A Whirlpool 22 years old — replaced rollers twice at $40 each. Still runs. A Samsung 5 years old — control board failed, $400 repair. The old one was more reliable.
Exception: motor + board + element all at once on a 15+ year-old machine — we'll do the math together. If the repair exceeds $400 and the dryer is over 12 years old, sometimes a new one makes more sense.
Average repair: $150. New dryer: $700–$1,500 plus wait time. Full breakdown: repair vs. replace →
If we don't fix it, you don't pay. You only pay $89 for the diagnostic (service call + analyzer). More about our guarantee →
We're based in Orange. Usually 2–3 hours from your call. 9 out of 10 dryer repairs are done same-day: belts, rollers, heating elements — we carry them in the van.
Yes, if the vent is clogged. Wet lint builds up → overheating → ignition. According to NFPA, roughly 2,900 dryer fires happen in the US every year.
We clean the vent duct free with every repair. If it's been a while — call us, we'll check it. Usually $80–$150 if it's just a cleaning with no repair.
70% of the time — yes, it's a clogged vent or flex hose. The element heats, but humid air can't escape. We check airflow with the analyzer.
The other 30%: moisture sensor or heating element running below capacity. The analyzer shows which one in under 5 minutes.
A handyman does a bit of everything. Appliance repair is its own licensed specialty in California.
We have a diagnostic analyzer for pinpoint accuracy, a van stocked with parts, and direct supplier relationships with Samsung, LG, Whirlpool, and Maytag. A handyman will Google it — we see these failures every day.
$89 — waived when you go ahead with the repair. If we don't fix it, you don't pay. You only pay the diagnostic fee if you decide not to proceed.
What customers say
★ ★ ★ ★ ★
Loud squeaking every rotation on our Samsung DV. Tech said Samsung drum rollers wear unevenly and you have to replace all four at once or the noise comes back in 6 months — replaced all of them. Silent now.
★ ★ ★ ★ ★
LG gas dryer not heating. Worried about safety. Tech found a cracked igniter, replaced it, and did a full gas leak check — all included. Fast and thorough.
★ ★ ★ ★ ★
Samsung dryer ran full cycles but clothes stayed damp. Heating element burned out. Fixed in 40 min for $200. New dryer would have been $1,100.
Useful pages
When fixing your dryer makes sense — and when it doesn't
tS, hE, dE — what they mean and what the repair costs
If we don't fix it, you don't pay. 90 days on parts and labor
Recent repairs nearby
35 min $170Gas dryer running cold. Owner concerned about gas leak.
35 min $140Dryer stopped spinning with wet clothes inside.
30 min $80Amy's dryer taking 3 hours per load. Electric bill doubled.
40 min $200Lisa ran 3 cycles — clothes still damp. Ready to buy a new dryer.
We repair all major dryer brands
Other dryer problems
Similar symptoms? Check if there's more than one thing going on.
Drum stalled, laundry piling up?
One call — drum spinning again
✓ Whirlpool/Amana-platform belts in the van
✓ Belt replacement — 30 minutes
✓ $80 flat labor rate
✓ If we don't fix it, you don't pay
7725 Gateway, Irvine, CA 92618
Пн-Пт 8:00-19:00
Ph: (949) 739-8878