80% of the time it's a snapped drive belt — and the design hasn't changed in 25 years, so we carry the part in the van. A visual check in about 5 minutes tells us exactly what failed (belt, rollers, idler or motor) before we quote a fixed price. If we don't fix it, you don't pay.
Same-day service
One look — about 5 minutes — and we know exactly what to fix before quoting.
The most common Whirlpool call. Motor hums, drum is frozen, sometimes a piece of rubber on the floor. Fixed in about 30 minutes.
Rollers worn flat — the drum sags and can't rotate, grinding before it stops. Always replaced in pairs.
The tensioner pulley seizes and the belt has nothing to run on. Often fails alongside the belt on older Whirlpools.
Rare on Whirlpool — they have some of the most reliable motors made. The analyzer reads amperage to confirm.
Complete silence at startup = no power reaching the motor. The door switch isn't signaling 'closed.'
Check the symptoms you're seeing to find the likely cause and repair cost
Check what you see on the left — we'll estimate the cause, the cost and how urgent it is.
Estimate only — the analyzer confirms the exact cause on-site.
Probable cause: belt, rollers, or thermal fuse. Repair: $100–$180, 30–45 minutes.
Probable cause: heating element + clogged vent, or moisture sensor. Repair: $120–$220, 30–60 minutes.
Multiple symptoms + burning smell — possible clogged vent (fire risk) or control board failure. Call immediately.
“Loud squeaking every rotation on our Samsung DV. Tech said Samsung drum rollers wear unevenly and you have to replace all four at once or the noise comes back in 6 months — replaced all of them. Silent now.”
“LG gas dryer not heating. Worried about safety. Tech found a cracked igniter, replaced it, and did a full gas leak check — all included. Fast and thorough.”
“Samsung dryer ran full cycles but clothes stayed damp. Heating element burned out. Fixed in 40 min for $200. New dryer would have been $1,100.”
★★★★★ 5.0 average · 29 verified reviews
We plug in the analyzer — in 5 minutes you see amperage on the element, air temp and vent airflow on the screen. The same data we read.
A clogged vent is a fire hazard — NFPA logs ~2,900 dryer fires a year in the US. We check and clean the duct with every repair.
Approve the repair and the $89 diagnostic is included. 90-day guarantee on all work, plus a 30-day follow-up call.
The average tech guesses: "not heating — swap the element." Didn't help. "Then the thermal fuse." Still nothing — you pay three times. Our analyzer reads amperage, air temp and vent airflow in 5 minutes. One part, one visit.
Whirlpool dryer specialist · Orange
Whirlpool belt jobs are the simplest repair in appliance service — the design hasn't changed in 25 years. Motor hums, drum is completely still, sometimes there's a piece of rubber on the floor. That's the belt.
Key distinction: motor humming but the drum still = belt or rollers. Complete silence = thermal fuse or door switch. Two very different issues, but the first is an easy fix.
My Whirlpool recommendation: if the belt snapped and the machine is 8+ years old, I replace the rollers and idler pulley at the same time — same disassembly, and it saves you a second labor charge six months from now. I'll tell you honestly on-site whether they need it.
You approve a fixed price before any work — then it doesn't move.
Lisa ran 3 cycles — clothes still damp. Ready to buy a new dryer.
Heating element burned out. Thermal fuse intact.
Gas dryer running cold. Owner concerned about gas leak.
Cracked igniter — no spark. Gas supply and connections safe.
Dryer stopped spinning with wet clothes inside.
Drive belt snapped. Drum rollers partially worn.
If your Whirlpool is 8+ years old — yes. Rollers and belt are in the same assembly, so a second visit for the rollers adds labor. The combo (belt + 2 rollers + idler pulley) is much cheaper than two separate service calls. On a newer machine (3–5 years), the belt alone is fine. I'll check the roller condition on-site and tell you.
Usually one roller worse than the other — the drum wobbles and lurches. Keep running it and it will snap the belt and score the shaft. Fix the roller pair before it becomes a bigger job.
The relay fires but the motor isn't starting — could be the motor start winding, a door switch losing signal, or a capacitor. The analyzer identifies the failing component in about 5 minutes.
Most dryer repairs run $120–$220 total (labor + part). The most common issues — belt, rollers, heating element — are $20–$140 for the part and $80 for labor. We quote the exact price before we start, after diagnostics.
Depends on the machine. Here's how Dmitry looks at it:
Dryers are the most repair-friendly appliance out there. Parts are simple and cheap: belt $20, rollers $40, element $80, thermal fuse $15. They last for years — no sensitive electronics dying after three.
Real example: A Whirlpool 22 years old — replaced rollers twice at $40 each. Still runs. A Samsung 5 years old — control board failed, $400 repair. The old one was more reliable.
Exception: motor + board + element all at once on a 15+ year-old machine — we'll do the math together. If the repair exceeds $400 and the dryer is over 12 years old, sometimes a new one makes more sense.
Average repair: $150. New dryer: $700–$1,500 plus wait time. Full breakdown: repair vs. replace →
If we don't fix it, you don't pay. You only pay $89 for the diagnostic (service call + analyzer). More about our guarantee →
We're based in Orange. Usually 2–3 hours from your call. 9 out of 10 dryer repairs are done same-day: belts, rollers, heating elements — we carry them in the van.
Yes, if the vent is clogged. Wet lint builds up → overheating → ignition. According to NFPA, roughly 2,900 dryer fires happen in the US every year.
We clean the vent duct free with every repair. If it's been a while — call us, we'll check it. Usually $80–$150 if it's just a cleaning with no repair.
70% of the time — yes, it's a clogged vent or flex hose. The element heats, but humid air can't escape. We check airflow with the analyzer.
The other 30%: moisture sensor or heating element running below capacity. The analyzer shows which one in under 5 minutes.
A handyman does a bit of everything. Appliance repair is its own licensed specialty in California.
We have a diagnostic analyzer for pinpoint accuracy, a van stocked with parts, and direct supplier relationships with Samsung, LG, Whirlpool, and Maytag. A handyman will Google it — we see these failures every day.
$89 — waived when you go ahead with the repair. If we don't fix it, you don't pay. You only pay the diagnostic fee if you decide not to proceed.
Describe what your dryer is doing and we'll reply the same day.
Similar symptoms? Check if there's more than one thing going on.
Same-day appliance repair across 40+ Orange County cities — from the coast to the canyons. If we don't fix it, you don't pay.
Same-day slots in Orange County, CA · If we don't fix it, you don't pay