300, 500 or 800 Series — Bosch's 24" compact ventless dryers, built for condo laundry rooms. Heat-pump 800 or condenser 300/500, we know them all. We diagnose with an analyzer in about 5 minutes and quote a fixed price before any work. If we don't fix it, you don't pay.
Same-day service
Tap your symptom — or just call and we'll sort it out on-site.
The condenser heat exchanger needs cleaning every 6–12 months — most owners don't know this. Cycle time climbs from 90 to 180 minutes without it. A 30-minute clean restores it, no parts.
On 300/500 — heating element or thermostat. On 800 heat-pump — a clogged condenser HX or a compressor issue.
Bosch runs at 47–49 dB, so any new sound stands out. Trolley wheels (Bosch uses wheels, not rollers) squeak after year 8. The analyzer pinpoints it fast.
A clogged condensate pump or a faulty float sensor — the dryer collects water but can't move it, or falsely reads 'full'. Pump or sensor swap in one visit.
Check the symptoms you're seeing to find the likely cause and repair cost
Check what you see on the left — we'll estimate the cause, the cost and how urgent it is.
Estimate only — the analyzer confirms the exact cause on-site.
Probable cause: belt, rollers, or thermal fuse. Repair: $100–$180, 30–45 minutes.
Probable cause: heating element + clogged vent, or moisture sensor. Repair: $120–$220, 30–60 minutes.
Multiple symptoms + burning smell — possible clogged vent (fire risk) or control board failure. Call immediately.
“Loud squeaking every rotation on our Samsung DV. Tech said Samsung drum rollers wear unevenly and you have to replace all four at once or the noise comes back in 6 months — replaced all of them. Silent now.”
“LG gas dryer not heating. Worried about safety. Tech found a cracked igniter, replaced it, and did a full gas leak check — all included. Fast and thorough.”
“Samsung dryer ran full cycles but clothes stayed damp. Heating element burned out. Fixed in 40 min for $200. New dryer would have been $1,100.”
★★★★★ 5.0 average · 29 verified reviews
We plug in the analyzer — in 5 minutes you see amperage on the element, air temp and vent airflow on the screen. The same data we read.
A clogged vent is a fire hazard — NFPA logs ~2,900 dryer fires a year in the US. We check and clean the duct with every repair.
Approve the repair and the $89 diagnostic is included. 90-day guarantee on all work, plus a 30-day follow-up call.
The average tech guesses: "not heating — swap the element." Didn't help. "Then the thermal fuse." Still nothing — you pay three times. Our analyzer reads amperage, air temp and vent airflow in 5 minutes. One part, one visit.
Bosch compact dryer specialist · Orange
Bosch dryers in the US are always 24" compact — built for the condo and townhouse laundry spaces common in Irvine, Newport Coast and coastal OC. The 300/500 Series are condenser ventless (they collect moisture in a tank); the 800 Series adds a heat-pump circuit that runs at 35–45 °C and stretches cycle time to 90–150 minutes.
The most common call: the dryer stops mid-cycle flagging a "full water tank" — but the tank is empty. That's a clogged condensate pump or a faulty float sensor, not a tank issue. Fixed in one visit.
Important for 800 Series owners: cycles that feel "not hot enough" are normal for heat-pump tech. A genuine failure shows as an empty condensate tank after a full load — not warm air.
You approve a fixed price before any work — then it doesn't move.
Lisa ran 3 cycles — clothes still damp. Ready to buy a new dryer.
Heating element burned out. Thermal fuse intact.
Gas dryer running cold. Owner concerned about gas leak.
Cracked igniter — no spark. Gas supply and connections safe.
Dryer stopped spinning with wet clothes inside.
Drive belt snapped. Drum rollers partially worn.
It probably just needs a condenser clean. The internal heat exchanger accumulates lint and dramatically increases cycle time — from 90 minutes to 2.5+ hours. It's the #1 service call on the 800 Series. Cleaning takes about 30 minutes and restores normal performance with no parts.
The float sensor in the base pan or the condensate pump is at fault. The dryer collects water but the pump isn't moving it to the tank, or the sensor falsely reads 'full.' Pump or sensor replacement — one visit.
On the 800 Series heat-pump, the compressor-protection circuit blocks startup for 30 minutes after power is restored. Wait 30 minutes, then try again. If it still won't start, call us — it may be the control board.
Most dryer repairs run $120–$220 total (labor + part). The most common issues — belt, rollers, heating element — are $20–$140 for the part and $80 for labor. We quote the exact price before we start, after diagnostics.
Depends on the machine. Here's how Dmitry looks at it:
Dryers are the most repair-friendly appliance out there. Parts are simple and cheap: belt $20, rollers $40, element $80, thermal fuse $15. They last for years — no sensitive electronics dying after three.
Real example: A Whirlpool 22 years old — replaced rollers twice at $40 each. Still runs. A Samsung 5 years old — control board failed, $400 repair. The old one was more reliable.
Exception: motor + board + element all at once on a 15+ year-old machine — we'll do the math together. If the repair exceeds $400 and the dryer is over 12 years old, sometimes a new one makes more sense.
Average repair: $150. New dryer: $700–$1,500 plus wait time. Full breakdown: repair vs. replace →
If we don't fix it, you don't pay. You only pay $89 for the diagnostic (service call + analyzer). More about our guarantee →
We're based in Orange. Usually 2–3 hours from your call. 9 out of 10 dryer repairs are done same-day: belts, rollers, heating elements — we carry them in the van.
Yes, if the vent is clogged. Wet lint builds up → overheating → ignition. According to NFPA, roughly 2,900 dryer fires happen in the US every year.
We clean the vent duct free with every repair. If it's been a while — call us, we'll check it. Usually $80–$150 if it's just a cleaning with no repair.
70% of the time — yes, it's a clogged vent or flex hose. The element heats, but humid air can't escape. We check airflow with the analyzer.
The other 30%: moisture sensor or heating element running below capacity. The analyzer shows which one in under 5 minutes.
A handyman does a bit of everything. Appliance repair is its own licensed specialty in California.
We have a diagnostic analyzer for pinpoint accuracy, a van stocked with parts, and direct supplier relationships with Samsung, LG, Whirlpool, and Maytag. A handyman will Google it — we see these failures every day.
$89 — waived when you go ahead with the repair. If we don't fix it, you don't pay. You only pay the diagnostic fee if you decide not to proceed.
Send your model number and what it's doing — we'll reply the same day.
Similar symptoms? Check if there's more than one thing going on.
Same-day appliance repair across 40+ Orange County cities — from the coast to the canyons. If we don't fix it, you don't pay.
Same-day slots in Orange County, CA · If we don't fix it, you don't pay