Frigidaire dryer grinding or not heating?
Fixed today.
FFRE, FFSE, Affinity, Gallery — the Electrolux platform means affordable parts and quick turnaround. We diagnose with an analyzer in about 5 minutes, quote a fixed price up front, and check the vent free. If we don't fix it, you don't pay.
Same-day service
What's happening with your Frigidaire?
Tap your symptom — or just call and we'll sort it out on-site.
Grinding / squeaking (Affinity)
The Affinity rear drum bearing is the top noise complaint — it grinds for months before it snaps the belt. Catch it early and you save the drum shaft and belt.
Not heating (runs cold)
Heating element burnout is the #1 Frigidaire failure — shorter service life than Whirlpool (5–7 yrs). An inexpensive Electrolux-platform part.
Takes too long to dry
MoistureSense sensor fouled by softener film (wipe first), a clogged vent, or a thermistor reading low. We bring a 30-ft auger for the duct.
Won't start
Door switch is the #1 cause. On Affinity electronic models, a panel freeze after a power surge — diagnosed instantly with a multimeter.
Quick Diagnosis: What's happening?
Check the symptoms you're seeing to find the likely cause and repair cost
What's the likely fix?
Check what you see on the left — we'll estimate the cause, the cost and how urgent it is.
Estimate only — the analyzer confirms the exact cause on-site.
Probable cause: belt, rollers, or thermal fuse. Repair: $100–$180, 30–45 minutes.
Probable cause: heating element + clogged vent, or moisture sensor. Repair: $120–$220, 30–60 minutes.
Multiple symptoms + burning smell — possible clogged vent (fire risk) or control board failure. Call immediately.
Frigidaire dryer reviews
“Loud squeaking every rotation on our Samsung DV. Tech said Samsung drum rollers wear unevenly and you have to replace all four at once or the noise comes back in 6 months — replaced all of them. Silent now.”
“LG gas dryer not heating. Worried about safety. Tech found a cracked igniter, replaced it, and did a full gas leak check — all included. Fast and thorough.”
“Samsung dryer ran full cycles but clothes stayed damp. Heating element burned out. Fixed in 40 min for $200. New dryer would have been $1,100.”
★★★★★ 5.0 average · 29 verified reviews
What you get in one visit
Analyzer diagnostic
We plug in the analyzer — in 5 minutes you see amperage on the element, air temp and vent airflow on the screen. The same data we read.
Free vent inspection
A clogged vent is a fire hazard — NFPA logs ~2,900 dryer fires a year in the US. We check and clean the duct with every repair.
Can't fix it — no charge
Approve the repair and the $89 diagnostic is included. 90-day guarantee on all work, plus a 30-day follow-up call.
Why we fix your dryer right the first time
The average tech guesses: "not heating — swap the element." Didn't help. "Then the thermal fuse." Still nothing — you pay three times. Our analyzer reads amperage, air temp and vent airflow in 5 minutes. One part, one visit.
Dmitry — dryer & vent specialist
Frigidaire / Electrolux specialist · Orange
Frigidaire is the value tier of Electrolux — and that shared platform is great news for repair. Parts are widely available, competitively priced, and cross-reference with Electrolux, so most repairs finish in a single visit.
The two patterns I see most: heating-element failure on FFRE/FFSE around year 5–7, and rear drum-bearing grinding on Affinity front-loaders. The Affinity bearing announces itself with a loud grinding 3–6 months before it snaps the belt — that sound should not be ignored; catching it early saves the drum shaft and the belt.
MoistureSense sensors are sensitive to fabric-softener buildup too — a wipe with rubbing alcohol often resolves "takes too long to dry" with no parts at all.
No price-list games, no surprises
You approve a fixed price before any work — then it doesn't move.
Recent Frigidaire dryer repairs in Orange
Lisa ran 3 cycles — clothes still damp. Ready to buy a new dryer.
Heating element burned out. Thermal fuse intact.
Gas dryer running cold. Owner concerned about gas leak.
Cracked igniter — no spark. Gas supply and connections safe.
Dryer stopped spinning with wet clothes inside.
Drive belt snapped. Drum rollers partially worn.
My Frigidaire Affinity makes a loud grinding sound — what is it?
Almost certainly the rear drum bearing — the most common serious failure on Affinity front-load dryers. It grinds for months and then snaps the belt. Don't wait: replacing the bearing now is far cheaper than replacing the bearing, belt and possibly the drum shaft later.
My dryer runs a full cycle but the clothes are still damp
First, wipe the MoistureSense sensor bars inside the drum with rubbing alcohol — softener film is the #1 cause. If that doesn't help, it's a thermistor or a clogged vent. We check all three on-site.
What does dryer repair actually cost?
Most dryer repairs run $120–$220 total (labor + part). The most common issues — belt, rollers, heating element — are $20–$140 for the part and $80 for labor. We quote the exact price before we start, after diagnostics.
Should I just buy a new dryer?
Depends on the machine. Here's how Dmitry looks at it:
Dryers are the most repair-friendly appliance out there. Parts are simple and cheap: belt $20, rollers $40, element $80, thermal fuse $15. They last for years — no sensitive electronics dying after three.
Real example: A Whirlpool 22 years old — replaced rollers twice at $40 each. Still runs. A Samsung 5 years old — control board failed, $400 repair. The old one was more reliable.
Exception: motor + board + element all at once on a 15+ year-old machine — we'll do the math together. If the repair exceeds $400 and the dryer is over 12 years old, sometimes a new one makes more sense.
Average repair: $150. New dryer: $700–$1,500 plus wait time. Full breakdown: repair vs. replace →
What if you can't fix it?
If we don't fix it, you don't pay. You only pay $89 for the diagnostic (service call + analyzer). More about our guarantee →
How fast can you get here?
We're based in Orange. Usually 2–3 hours from your call. 9 out of 10 dryer repairs are done same-day: belts, rollers, heating elements — we carry them in the van.
Is a dryer actually a fire risk?
Yes, if the vent is clogged. Wet lint builds up → overheating → ignition. According to NFPA, roughly 2,900 dryer fires happen in the US every year.
We clean the vent duct free with every repair. If it's been a while — call us, we'll check it. Usually $80–$150 if it's just a cleaning with no repair.
Taking too long to dry — is that a breakdown?
70% of the time — yes, it's a clogged vent or flex hose. The element heats, but humid air can't escape. We check airflow with the analyzer.
The other 30%: moisture sensor or heating element running below capacity. The analyzer shows which one in under 5 minutes.
How are you different from a handyman?
A handyman does a bit of everything. Appliance repair is its own licensed specialty in California.
We have a diagnostic analyzer for pinpoint accuracy, a van stocked with parts, and direct supplier relationships with Samsung, LG, Whirlpool, and Maytag. A handyman will Google it — we see these failures every day.
How much is the diagnostic fee?
$89 — waived when you go ahead with the repair. If we don't fix it, you don't pay. You only pay the diagnostic fee if you decide not to proceed.
Have a Frigidaire Question? Ask Us
Describe what your Frigidaire is doing and we'll reply the same day.
Other dryer problems
Similar symptoms? Check if there's more than one thing going on.
We Cover All of Orange County
Same-day appliance repair across 40+ Orange County cities — from the coast to the canyons. If we don't fix it, you don't pay.
Book a Frigidaire dryer tech
- FFRE / FFSE · Affinity · Gallery — every series
- Electrolux-platform parts in the van
- Diagnostic analyzer: $89 (waived at repair)
- If we don't fix it, you don't pay · 90-day guarantee + 30-day follow-up call